The left button cannot be used for triggerhappy right now, since it doesn't support configuring numeric key codes.254 (name neither listed by libinput, nor linux/input.h) Other button (left of the home button).KEY_BACK Back button (right of the home button).If you are running elogind, make sure to prevent it from handling the power button, by setting HandlePowerKeyIgnore in nf.Use triggerhappy to configure what the buttons do.Check dmesg for messages containing "dhdsdio_download_firmware", to see if there was an error loading the firmware.using wlan0 or p2p0 fails with "Operation not permitted".Make sure "deferred-initcalls" has been started.When using networkmanager, you should now be able to connect to a network: restart networkmanager and / or wpa_supplicant and / or whatever you want to do with networking.Wifi requires firmware blobs to be installed:Īfter installation, either reboot the device, or: After that you should be able to setup and connect via SSH Getting Wifi to work It should boot, and show the Samsung splash screen. pmbootstrap.py flasher flash_kernel, but if you followed the recovery ROM steps then you don't need to do this. You can try to reinstall with a different cipher, by editing install_options and changing the CIPHER line to CIPHER="aes-cbc-plain64", re-zipping and using adb sideload again. If you get an error lddtree not found, simply run apk add lddtree in the chroot environment and try again.ĭevice-mapper: reload ioctl on failed: No such file or directoryįailed to setup dm-crypt key mapping for device /dev/block/mmcblk0p18.Ĭheck that kernel supports aes-xts-plain64 cipher (check syslog for more info). log files, it seems to work on second try but due to another issue you have to make sure SYSTEM is unmounted in TWRP before attempting to do so. Currently on Samsung devices you may get an error about unmounting. Then just flash it via recovery as you would a normal android ROM. Heimdall is currently unable to flash the SYSTEM partition, and adb sideload method seems broken, so you will have to do pmbootstrap export after generating the recovery and pushing it to the phone while it is booted in TWRP via adb push /tmp/postmarketOS-export/pmos-samsung-kminilte.zip /sdcard/. Note: Be aware that the stock Android ROM reflashes stock recovery upon boot, wiping TWRP out if you let it start booting.įollow the android-recovery-zip steps, using samsung-kminilte when the init commands asks. Now you should be able to connect to the device using adb. $ heimdall flash -RECOVERY recovery.img -BOOT twrp-3.2.3-0-kminilte.img Then, put your phone in flash mode and flash using Heimdall: First, extract the tar file to obtain recovery.img. If you comment out that line in start_weston.sh and replace it by udevadm trigger -attr-match=name=sec_touchscreen, the touch screen should work.įirst, download the TWRP recovery ROM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |